ASCU2 Gen. 5+ for Gearbox V.3, is a two-piece electronic module (command unit and sensor unit), which once installed in the airsoft replicas significantly improves its operation.
ASCU-2 Gearbox V3 (GEN. 5+ TECHNOLOGY) AIRSOFT SYSTEMS
ASCU2 Gen. 5+ for Gearbox V.3, is a two-piece electronic module (command unit and sensor unit), which once installed in the airsoft replicas significantly improves its operation. A traditional connector circuit was replaced by a sensor unit that monitors the current location of the sector gear, trigger mode selector and trigger. The information collected is transmitted to the command unit; there the software in the CPU analyzes them and controls the engine of the replica by means of the active MOSFET brake.
The ASCU-2 is so small that it fits in any Gearbox V3 and acts as a computerized MOSFET system, causing your AEG to shoot with an accuracy that could be compared to PTW.
The entire firing process is controlled by computer and causes each trigger trigger to develop a complete cycle, thus giving a realistic feeling when firing. It is compatible with LiPo, Life, NiMH, NiCd from 7.2 - 12 Volts
Easy to install It is not necessary to modify the Gearbox or welds.
You can change to different shooting modes:
Safe + Semi + 3 Rnd Burst + Auto
Safe + Semi + Auto (The most common)
Safe + Semi + 3 Rnd Burst
Safe + Semi (For games with certain rules)
News Gen 5:
1. New transistor with 16 times less resistance. Faster cycles, better active brake, more shots per battery and less heating.
2. New and strong trigger actuator.
3. Reinforced design with polymer cover.
4. Better circuit protection.
5. Easy installation
6. Updated software easier to program (accidental hop-up activation impossible).
7. Cut-off lever improved.
8. Selector plate improved.
